O'Reilly logo

31 Days Before Your CCENT Certification by Scott Bennett

Stay ahead with the world's most comprehensive technology and business learning platform.

With Safari, you learn the way you learn best. Get unlimited access to videos, live online training, learning paths, books, tutorials, and more.

Start Free Trial

No credit card required

CCNA Discovery 2, Chapter 6

6.1.5: To configure RIPv2 on a network, follow these steps:

Step 1. Physically connect the routers, power up each router, and check the LEDs to ensure connectivity.

Step 2. Plan an IP addressing scheme that provides sufficient addresses for all networks connected to each router.

Step 3. Connect to each router with a console cable (out-of-band management), configure the proper IP address, and activate each interface.

Step 4. Determine which networks are directly connected to each router, and use RIP to configure that router to advertise the location of those networks.

The following commands allow you to enable RIP on a router directly connected to a specific network:

router rip version 2 network directly-connected-network ...

With Safari, you learn the way you learn best. Get unlimited access to videos, live online training, learning paths, books, interactive tutorials, and more.

Start Free Trial

No credit card required