Hardware and Software Requirements
Circuit connections to the DAQ require a cable and a facility for connecting to individual pins. An efficient system is based on a National Instruments Connector Block (CB-68LP) and a basic circuit board as shown here.
Connections to the circuit board from the connector block are made one time. The two resistors of the circuit are connected to output channels 0 and 1, respecively. Thus, for example, Chan0_out, as noted, is dedicated to the top strip on the circuit board. The bottom top strip is associated with Chan0_in, and so forth.
All of the project LabVIEW files are programmed to be consistent with the plus ...