Editing Wall Joins

There is a separate function in Revit that deals with editing wall joins specifically: the Edit Wall Joins command. It can come in quite handy. To get started, let's add more walls to an already busy corner of the building:

  1. Zoom into the northeast corner of the building, as shown in Figure 2.48.
  2. Start the Wall command. Make sure it's the same 6 1/8″ (135mm) two-hour partition you've been using.

    image

    FIGURE 2.48 The northeast corner

  3. With the Chain button off and Location Line set to Finish Face: Interior, to start the wall, pick the intersection where the CMU wall abuts the finish inside face of the exterior wall (see Figure 2.49 ...

Get Autodesk® Revit® Architecture 2012: No Experience Required now with the O’Reilly learning platform.

O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.

Start your free trial