Chapter 14 Multicast
Lab 14-1: IGMP
Figure 14-1 illustrates the topology that will be used in the following lab.
Enable multicast routing on R1 and R2 and configure their F0/0 and F0/1 interfaces in PIM dense mode.
There are two types of multicast routing protocols: dense mode and sparse mode. Dense mode uses a push model, meaning that the multicast traffic is flooded throughout the network. This is called a flood and prune model because initially the traffic is flooded to the network, but after the initial flood the routers with no receivers are pruned.
On both R1 and ...