Written Lab 6
Write out the command or commands for the following questions:
1. What command is used to set a serial interface to provide clocking to another router at 64 Kb?
2. If you telnet into a router and get the response connection refused, password not set, what commands would you execute on the destination router to stop receiving this message and not be prompted for a password?
3. If you type show inter ethernet 0 and notice the port is administratively down, what commands would you execute to enable the interface?
4. If you wanted to delete the configuration stored in NVRAM, what command(s) would you type?
5. If you wanted to set the user-mode password to todd for the console port, what command(s) would you type?
6. If you wanted to ...