Enabling VTP

The VTP is disabled by default on the device. You can enable and configure VTP using the command-line interface (CLI). When VTP is disabled, the device does not relay any VTP protocol packets. To enable VTP on a Nexus switch, use the command feature vtp. By default, the switch will then be in VTP server mode. Example 10-5 shows the enabling and verification of VTP.

Image

Example 10-5 VTP Enablement and Verification

Click here to view code image

SW1# show vtp % Invalid command at '^' marker. SW1# configure terminal SW1(config)# feature vtp SW1(config)# show vtp status VTP Status Information ---------------------- VTP Version                     : ...

Get CCNA Data Center DCICN 640-911 Official Cert Guide now with the O’Reilly learning platform.

O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.

Start your free trial