This chapter describes the tasks for configuring policy-based routing (PBR) on a router. To locate documentation of related commands, you can search online at http://www.cisco.com.
To configure PBR, perform the tasks in the following sections:
Enable PBR
Enable Fast-Switched PBR
Enable Local PBR
The section "PBR Configuration Examples" later in this chapter provides examples of configuring PBR.
To enable PBR, you must create a route map that specifies the match criteria and the resulting action if all of the match clauses are met. Then you must enable PBR for that route map on a particular interface. All packets arriving on the specified interface matching the match clauses ...
No credit card required