Ctrl-click on the Vertex sub-object button. This converts your
open edge selection to the vertices that make up that open
edge. Now click Weld. We now have a nice solid blade!
Put another TurboSmooth modifier on your object, set Itera-
tions to 2, check Isoline again, and go back under your
Editable Poly modifier. Be sure to click the Show End Result
button.
220Chapter 10
Figure 10-15: Both halves now attached
Figure 10-16: The blade now looking quite dull
Here we go again! The outer edge of the blade has been
smoothed out! You know what to do about that ...
Become an O’Reilly member and get unlimited access to this title plus top books and audiobooks from O’Reilly and nearly 200 top publishers, thousands of courses curated by job role, 150+ live events each month, and much more.