
431CoatingsforfsLasers
Chapter 15
0.633J/cm
2
. Obviously,thedesignshis the position of the highest sensitivity from the
layer no. 1 into the stack by stabilizing the layers close to the surface and, as expected,
the threshold of the component increases. In Figure 15.21, the comparison of the mea-
sured and calculated values conrms a perfect match, and therefore, an optimization
of the design can be performed, following.
15.7 Optimization of Power-Handling
Capability of RISED Stacks
e optimization of the stack uses the calculation of the damage threshold. e algo-
rithm is equivalent to the design optimization of thin lm stacks with respec ...