
apart for your switch plate; these come in
a “home” size, where the holes are closer
together, and a larger “office” spacing.
2. ADD A SERVO AND “FINGER”
For the flat rocker switch, the servomotor
lies flat, parallel to the wall; mount it to the
sled using the two M2 screws (Figures
F
and
G
). For the lever type, you’ll mount
the servo vertically using 2 small cable ties
(Figure
H
). This means the flat switch ends
up looking nicer than the lever kind, but you
probably can’t choose your switches.
Super-glue the acrylic servo “finger”
to the servo horn (Figures
I
and
J
).
Again, there are 2 different kinds of finger,
depending on your switch.
3. INSER ...