It is possible to re-record a section over and over again using the Cycle mode of the transport. Cycle playback uses the left and right locators to determine the beginning and end of the cycle.
1. Set the left and right locators to the start and end of the cycle you wish to record. (See Figure 6.9.)
2. Enable cycle playback on the Transport panel. (See Figure 6.10.)
3. Start recording from the left locator. Once the right locator has been reached, the cursor will jump back to the left locator and continue recording.
4. After recording five takes, you will have each take in a lane with the last complete one active. (See Figure 6.11.)