You want to configure Bridge Groups for wired/wireless networks to share IP addresses and make the networks seamless.
Configure the zone that will contain the wired and wireless network and assign
bgroup0 to the zone. Also, assign the wired interface and wireless interface to the
set zone name Corp set interface "bgroup0" zone "Corp" set interface bgroup0 port ethernet0/6 set interface bgroup0 port wireless0/0
Then, configure the IP address for the
bgroup0 interface and enable DHCP for automatic IP address allocations:
set interface bgroup0 ip 10.10.10.1/24 set interface bgroup0 dhcp server service set interface bgroup0 dhcp server enable set interface bgroup0 dhcp server option gateway 10.10.10.1 set interface bgroup0 dhcp server option netmask 255.255.255.0 set interface bgroup0 dhcp server ip 10.10.10.100 to 10.10.10.130
Configure the SSID for the wireless network, and bind the wireless interface to the SSID. Then, activate the wireless configuration:
set ssid name Secured set ssid Secured client-isolation set ssid Secured authentication wpa-auto-psk passphrase Secret encryption auto set ssid Secured interface wireless0 exec wlan reactivate
Finally, configure the security policy to allow traffic across zones:
set policy from corp to untrust any any any nat src permit
You can use Bridge Groups to combine wired and wireless interfaces at the Layer 2 level and make the network seamless. ...