Section 1: Bridging and Switching (16 Points)
Section 1.1: Frame Relay Configuration (6 Points)
Configure the Frame Relay portion of the network as shown in Figure 2-11 and ensure that DLCIs 110 and 104 between R1 and R6 are not used.
The question clearly states that DLCIs 110 and 104 are not to be used; you must, therefore, disable inverse-arp on the routers. It is good practice to ensure that all routers do not rely on inverse-arp so if you have configured no frame-relay inverse-arp under routers R1, R4, and R6 serial interfaces, you have scored 1 point.
If you experience difficulties and can not clear any dynamic map entries, reload your routers to remove these, a drastic measure but every point counts.
Use point-to-point subinterfaces with ...
Get CCIE Routing and Switching Practice Labs now with the O’Reilly learning platform.
O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.
