CCNP Routing and Switching ROUTE 300-101 Official Cert Guide

Setting Metrics When Redistributing

Setting a different metric for different redistributed routes requires only a minor amount of additional configuration. The redistributing router still needs a route map and still needs to match the routes. Additionally, to set the metric for routes matched by a particular clause, the route map needs the set metric route map subcommand. When redistributing into EIGRP, this command has five parameters (bandwidth, delay, reliability, load, and MTU). When redistributing into OSPF or Routing Information Protocol (RIP), a single integer metric is used.

Configuring the Metric Settings

Continuing with the same internetwork shown in Figure 10-11, and with the same filtering goals summarized earlier in Table 10-8