Deploying IBM Workplace Services Express on the IBM eServer iSeries Server

Chapter 7. Integrating iSeries Access for Web portlets 229

– port: The port on which the HTTP server assigned to this Workplace Services Express

instance is running

This is typically port 80, unless you specified a nonstandard port when configuring your

Workplace Services Express server.

For our example, we entered the following command:

cfgaccweb2 -appsvrtype *WSE -wasinst ITSOWSE1 -wpusrid wpsadmin -wppwd password -wpurl

itsowse1.rchland.ibm.com/lwp/config -wppag *YES

6. The cfgaccweb2 command runs and several messages are displayed (Figure 7-31). After

the cfgaccweb2 command completes, iSeries Access for Web is configured on your

Workplace Services Express server.

Figure 7-31 Output of the cfgaccweb2 command

7.4 Configuring the iSeries Access for Web portlets

After the iSeries Access portlets are installed, you see a new My iSeries tab in your

Workplace Services Express server. See Figure 7-32.

Depending on the method of authentication which you choose to use with the iSeries Access

for Web portlets, you might have to perform some configuration before using the portlets. If

you configured EIM, as explained in 7.1, “Configuring EIM for use with the iSeries Access

portlets” on page 209, no further configuration is needed. You can start using the portlets to

access information on your iSeries server. If you did not configure EIM, you must set some

authentication information in the portlet’s configuration mode.

QSH Command Entry

Configuring iSeries Access for Web

Preparing to perform the configuration changes.

Calling Portal Server to perform the configuration changes.

Refer to the following log file for additional success/failure information:

/QIBM/UserData/Access/Web2/wse/itsowse1/logs/cfgwseiwa.log

Refer to the following log file for additional success/failure information:

/QIBM/UserData/Access/Web2/wse/itsowse1/logs/cfgwseiwapage.log

iSeries Access for Web command has completed.

===>

F3=Exit F6=Print F9=Retrieve F12=Disconnect

F13=Clear F17=Top F18=Bottom F21=CL command entry