338 Deployment Guide Series: IBM Tivoli Monitoring V6.2
5.5 Integrating the Netcool and OMNIbus events to the
Common Event Console example
This section describes an example of IBM Tivoli Monitoring V6.2 event
integration.
First, we configure the Common Event Console to concentrate events from IBM
Tivoli Monitoring itself, Tivoli Enterprise Console, and Netcool/OMNIbus in the
same workspace. To achieve this target, some customization has been made.
TEMS has a default ITM connector configuration, as you can see in Figure 5-7.
Figure 5-7 ITM Connector configuration
340 Deployment Guide Series: IBM Tivoli Monitoring V6.2
To configure the OMNIbus Connector, select the respective folder, click New, and
complete the parameters, as shown in Figure 5-9.
Figure 5-9 OMNIbus connector tab
In Figure 5-10 on page 341, there is a sample of the Common Enterprise
Console with three connectors: ITM, TEC, and Netcool/OMNIbus.
Note: The other parameters that are not shown above were left with the
default values.
342 Deployment Guide Series: IBM Tivoli Monitoring V6.2
In the situation configuration, click the EIF folder to select the EIF Receiver for
the situation alert, as shown in Figure 5-12.
Figure 5-12 EIF receivers
This example of a situation was used to generate an event to Netcool/OMNIbus.
An alert where Alert Group has the value of ITM_Linux_Disk was received by
Netcool/OMNIbus. Figure 5-13 shows the native Netcool/OMNIbus console.
Figure 5-13 Netcool/OMNIbus event list
The user can acknowledge the event on the TEP workspace, as shown in
Figure 5-14 on page 343.
Get Deployment Guide Series: IBM Tivoli Monitoring V6.2 now with the O’Reilly learning platform.
O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.