198 IBM PureFlex System and IBM Flex System Products and Technology
For the latest list of supported operating systems, see IBM ServerProven at:
http://www-03.ibm.com/systems/info/x86servers/serverproven/compat/us/nos/flexmatri
x.shtml
5.4 IBM Flex System p260 and p24L Compute Nodes
The IBM Flex System p260 Compute Node and IBM Flex System p24L Compute Node are
based on IBM POWER architecture technologies. These compute nodes run in IBM Flex
System Enterprise Chassis units to provide a high-density, high-performance compute node
environment by using advanced processing technology.
This chapter describes the server offerings and the technology used in their implementation.
5.4.1 Specifications
The IBM Flex System p260 Compute Node is a half-wide, Power Systems compute node with
these characteristics:
Two POWER7 processor sockets
Sixteen memory slots
Two I/O adapter slots
An option for up to two internal drives for local storage
The IBM Flex System p260 Compute Node has the specifications shown in Table 5-46.
Table 5-46 IBM Flex System p260 Compute Node specifications
Remember: The IBM Flex System p260 Compute Node can be ordered only as part of
IBM PureFlex System as described in Chapter 2, “IBM PureFlex System” on page 11.
Components Specification
Model numbers 7895-22X.
Form factor Half-wide compute node.
Chassis support IBM Flex System Enterprise Chassis.
Processor Two IBM POWER7 processors. Each processor contains either eight cores (up
to 3.55 GHz and 32 MB L3 cache) or four cores (3.3 GHz and 16 MB L3 cache).
Each processor has 4 MB L3 cache per core. Integrated memory controller in
each processor, each with four memory channels. Each memory channel
operates at 6.4 Gbps. One GX++ I/O bus connection per processor. Supports
SMT4 mode, which enables four instruction threads to run simultaneously per
core.
Chipset IBM P7IOC I/O hub.
Memory 16 DIMM sockets. RDIMM DDR3 memory supported. Integrated memory
controller in each processor, each with four memory channels. Supports IBM
Active Memory™ Expansion with AIX 6.1 or later. All DIMMs operate at 1066
MHz. Both LP (low profile) and VLP (very low profile) DIMMs supported,
although only VLP DIMMs are supported if internal HDDs are configured. The
use of 1.8-inch solid-state drives allows the use of LP and VLP DIMMs.
Memory
maximums
256 GB using 16x 16 GB DIMMs.