To start the Wedge command, you can type the command name WEDGE (or just type WED) and then press Enter. Alternatively, you can click on the Wedge button found in the Create panel in the 3D Basics workspace. If you are using the 3D Modeling workspace, you will find the Wedge button in the Modeling panel under the Home tab, or in the Primitive panel under the Solid tab, as shown in the following screenshot:
Figure 11.51: Alternative methods to start the Wedge command
The Wedge command is used to quickly and easily create 3D solid Wedges, as shown in the following step-by-step example:
- Choose a location and click to specify ...
