All steps performed in the previous section may be implemented at the OBP prompt; however, the process differs slightly.
The steps discussed in this section are for an OBP prompt only and are not suitable for running at the shell command prompt.
Set the environment-wide SCSI-initiator ID to 6 using the setenv command. Enter the following command into the OBP prompt:
ok setenv scsi-initiator-id 6
Because the preceding command sets an OBP environment variable (stored in NVRAM), the change becomes permanent automatically. Therefore, a script should be created to reset the local chain controller IDs back to 7. Create the script using the nvedit command.
The nvedit command starts a basic editor ...