The errata list is a list of errors and their corrections that were found after the product was released. If the error was corrected in a later version or reprint the date of the correction will be displayed in the column titled "Date Corrected".
The following errata were submitted by our customers and approved as valid errors by the author or editor.
Version |
Location |
Description |
Submitted By |
Date submitted |
Date corrected |
Printed |
Page xix-xx
The text of the first part of the "We'd Like to Hear from You" |
section has been updated. It now reads:
We'd Like to Hear from You
The information in this book has been tested and verified, but you may find
that features have changed (or you may even find mistakes!). Please tell us
about any errors you find, as well as your suggestions for improving future
editions, by writing or calling:
O'Reilly & Associates, Inc.
101 Morris Street
Sebastopol, CA 95472
(800) 998-9938 (in the United States or Canada)
(707) 829-0515 (international/local)
(707) 829-0104 (fax)
There is a web site for the book, where we list examples, errata, and any
additional information. You can access this page at:
http://www.oreilly.com/catalog/9781565925991/
To comment on the book or ask technical questions, send email to:
bookquestions@oreilly.com
For more information about our books, conferences, software, Resource Centers,
and the O'Reilly Network, see our web site at:
http://www.oreilly.com
|
Anonymous |
|
Feb 01, 2001 |
Printed |
Page 10
In the 8th line of the second paragraph under "System Resources," |
changed "if you are use" to "if you are using."
|
Anonymous |
|
Feb 01, 2001 |
Printed |
Page 143
|
The last entry in the variable list now reads:
168-pin RIMMs
It should read:
168/184-pin RIMMs
|
Anonymous |
|
|
Printed |
Page 210
In the section "Choosing a CD Writer," the first line under the |
subheading "CD-R versus CD-RW" did read:
"CD-R drives are somewhat more expensive than CD-R drives."
Now reads:
"CD-RW drives are somewhat more expensive than CD-R drives."
|
Anonymous |
|
Feb 01, 2001 |
Printed |
Page 218
Last paragraph, second line |
The first sentence under the bit-list reads:
By default, this bit mask is set to 10010101 (95H), which disables AutoRun for
removable drives, remote drives, and RAM disks.
It should be changed to:
By default, this bit mask is set to 10010101 (95H), which disables AutoRun for
DRIVE_UNKNOWN, DRIVE_REMOVABLE, and DRIVE_REMOTE. The high-order bit is also
set to disable AutoRun for reserved future devices.
|
Anonymous |
|
|
Printed |
Page 309
Second and third paragraphs |
The corrected text is as follows:
Resolution and refresh rate are interrelated parts of synchronization
range of an analog monitor. For a given resolution, increasing the refresh
rate increases the number of screens (and accordingly the amount of data)
that must be transferred each second. Similarly, for a given refresh rate,
increasing the resolution increases the amount of data that must be
transferred for each screen. If you increase resolution or refresh rate,
you may have to decrease the other to stay within the HSF limit on total
bandwidth.
Note that manufacturers often specify maximum resolution and maximum
refresh rate independently, without consideration for their
interrelatedness. For example, specifications for a 19" monitor may promise
1600X1200 resolution and 160 Hz refresh. Don't assume that means you can
run 1600X1200 at 160 Hz. 160 Hz refresh may be supported only at 640X480
resolution; at 1600X1200, the monitor may support only 70 Hz refresh.
|
Anonymous |
|
|
Printed |
Page 400
The last two sentences in the first paragraph under "ATX Optional |
Power Supply Connector" were repeated twice. The second set has been deleted.
|
Anonymous |
|
Feb 01, 2001 |
Printed |
Page 459-461
Figures 26-13 through 26-16 were out of order: |
- Figure 26-13 has been replaced with Figure 26-16 and its caption.
- Figure 26-14 has been replaced with Figure 26-15 and its caption.
- Figure 26-15 has been replaced with Figure 26-13 and its caption.
- Figure 26-16 has been replaced with Figure 26-14 and its caption.
|
Anonymous |
|
Feb 01, 2001 |
Printed |
Page 461
The last sentence in the first paragraph under "Step 4: Install the |
Memory" did read:
"Here is the exact procedure required to install memory modules differs
slightly for SIMMs versus DIMMs."
Now reads:
"The exact procedure required to install memory modules differs
slightly for SIMMs versus DIMMs:"
|
Anonymous |
|
Feb 01, 2001 |