IntroductionFollowing the Tutorials in This BookBeginning an AutoCAD DrawingSaving the DrawingSaveSave AsDWTDWSDXFDrawing Name and File Name ExtensionUnitsControlling Your DrawingDrawing ScaleDrawing Limits and the Cartesian Coordinate SystemGridGRIDDISPLAYSnapZoomDrafting Settings Dialog BoxLayersLayer ListsLinetypesLineweightsLineweight Settings Dialog BoxLWTAnnotation ScaleSaving the DrawingUsing the Mouse and Right-Click CustomizationOrthoDrawing Lines Using the Grid Marks and Snap IncrementsErase and UndoDrawing Lines Using Absolute CoordinatesDrawing Lines Using Relative CoordinatesDrawing Lines Using Polar CoordinatesDrawing Lines Using Direct Distance EntryDYNCircleCenter, RadiusCenter, Diameter2 Points3 PointsTTRLTSCALEZOOMZoom-WindowZoom-AllZoom-PreviousZoom-ExtentsZoom-ObjectZoom-RealtimePAN REALTIMETransparent CommandsREDRAWREGENHIGHLIGHTMove and Editing Commands Selection SetOptions for Selecting Objects to ModifyWindow (W) and Crossing Window (C)All (ALL)Fence (F)Remove (R) and Add (A)Last (L) and Previous (P)Undo (U)GripsUNDO and REDOARC3-PointStart, Center, EndStart, Center, AngleStart, Center, LengthStart, End, AngleStart, End, DirectionStart, End, RadiusContinueELLIPSEAxis, EndCenterDONUTSCALE<Scale factor>ReferenceAdding TextCommand Lines of Prompt HistoryPlot - NamePage SetupPrinter/PlotterPlot to FileBrowse for Plot File...Plot Style Table (Pen Assignments)Paper SizePlot AreaPlot ScaleAnnotative Property and Annotation ScalePlot Offset (Origin Set to Printable Area)Shaded Viewport OptionsPlot OptionsDrawing OrientationPreview...Chapter SummaryChapter Test QuestionsMultiple ChoiceMatchingTrue or FalseListGeneral QuestionsChapter ProjectsProject 2-1: Drawing Shapes I [BASIC]Project 2-2: Drawing a Pattern [BASIC]Project 2-3: Drawing Shapes II [INTERMEDIATE]Project 2-4: Drawing a Door [INTERMEDIATE]Project 2-5: Drawing Shapes III [ADVANCED]