RIP Version 2 Configuration on NX-OS

As you learned in Chapter 20, RIP is a distance vector routing protocol. This section describes how to enable RIPv2 (the default version on Cisco Nexus switches), validate configuration, and perform basic troubleshooting. Figure 21-1 shows routing between four Nexus switches—a topology common in today’s data centers. You will use this topology to configure RIPv2 in two ways:

Image RIPv2 enabled via routed interfaces

Image Based on SVI being enabled as the Layer 3 interface for routing protocol participation.

Figure ...

Get CCNA Data Center DCICN 640-911 Official Cert Guide now with the O’Reilly learning platform.

O’Reilly members experience books, live events, courses curated by job role, and more from O’Reilly and nearly 200 top publishers.