Auto-Negotiation Best Practices
Using auto-negotiation to your advantage is as easy as remembering one simple rule:
| Make sure that both sides of the link are configured the same way. |
If one side of the link is set to auto-negotiation, make sure the other side is also set to auto-negotiation. If one side is set to 100/full, make sure the other side is also set to 100/full.
Tip
Be careful about using 10/full, as full duplex is not supported on all 10Base-T Ethernet devices.
Gigabit Ethernet uses a substantially more robust auto-negotiation mechanism than the one described in this chapter. Gigabit Ethernet should thus always be set to auto-negotiation, unless there is a compelling reason not to do so (such as an interface that will not properly negotiate). Even then, this should be considered a temporary workaround until the misbehaving part can be replaced.
Become an O’Reilly member and get unlimited access to this title plus top books and audiobooks from O’Reilly and nearly 200 top publishers, thousands of courses curated by job role, 150+ live events each month,
and much more.
Read now
Unlock full access