August 2010
Intermediate to advanced
288 pages
13h 21m
English
All the programs presented so far have ended either because they reached the end of the Sequence Beam or because you pressed the Exit button on the NXT. The Stop block gives you a way to make a program end itself.
This block is very simple; it has no configuration items, and when it’s run, the program ends. You’ll find the Stop block on the Complete Palette in the Flow group, as shown in Figure 6-17. Figure 6-18 shows how it will look in your program.

Figure 6-17. The Stop block on the Complete Palette

Figure 6-18. The Stop block
Read now
Unlock full access