AutoCAD® 2010 and AutoCAD LT® 2010 Bible

Chapter 23. Creating 3D Surfaces

IN THIS CHAPTER

• Converting objects to surfaces

• Drawing surfaces with 3DFACE and PFACE

• Creating 3D polygon meshes

• Creating plane surfaces

• Drawing standard 3D shapes

• Drawing a revolved surface

• Creating extruded, ruled, lofted, and edge surfaces

• Working with surfaces, solids, and wireframes together

In this chapter, you learn to create all types of surfaces, also called meshes. Specifically, they are polygonal meshes. Surfaces have a great advantage over 3D wireframe models because you can hide back surfaces and create shaded images for easier visualization of your models. Surfaces also enable you to create unusual shapes, such as topological maps or free-form objects.

You cannot obtain information about physical properties — such as mass, center of gravity, and so on — from surfaces. Such information can be obtained only from 3D solids, which are covered in the next chapter.

Note

This chapter assumes that you are using the 3D Modeling Workspace.

Note

This entire chapter applies to AutoCAD only. For information on surfaces that AutoCAD LT can create, see Chapter 21.

The left side of Figure 23.1 shows a lamp drawn with surfaces. The back edges are hidden, so the lamp looks somewhat realistic. AutoCAD approximates curved surfaces by creating a mesh of planes at varying angles. You see the planes because AutoCAD displays them using a web of intersecting lines. AutoCAD defines the mesh by its vertices — where the lines intersect. The right side of Figure 23.1 shows a ...