20.2. Using the Bitwise Complement Operator with Various Data Types
Problem
The bitwise complement operator (~) is overloaded to work directly with int, uint, long, ulong, and enumeration data types consisting of the underlying types int, uint, long, and ulong. However, you need to perform a bitwise complement operation on a different numeric data type.
Solution
To use the bitwise complement operator with any data type, you must cast the resultant value of the bitwise operation to the type you wish to work with. The following code demonstrates this technique with the byte data type:
byte y = 1; byte result = (byte)~y;
The value assigned to result is 254.
Discussion
The following code shows incorrect use of the bitwise complement operator on the byte data type:
byte y = 1;
Console.WriteLine("~y = " + ~y);This code outputs the following surprising value:
-2
Clearly, the result from performing the bitwise complement of the byte variable is incorrect; it should be 254. In fact, byte is an unsigned data type, so it cannot be equal to a negative number. If you rewrite the code as follows:
byte y = 1; byte result = ~y;
you get a compile time error: "Cannot implicitly convert type 'int' to 'byte.'" This error message gives some insight into why this operation does not work as expected. To fix this problem, you must explicitly cast this value to a byte before you assign it to the result variable, as shown here:
byte y = 1; byte result = (byte)~y;
This cast is required because the bitwise operators ...
Become an O’Reilly member and get unlimited access to this title plus top books and audiobooks from O’Reilly and nearly 200 top publishers, thousands of courses curated by job role, 150+ live events each month,
and much more.
Read now
Unlock full access