Configuring IPX Routing Commands
As mentioned earlier in this chapter, you enable IPX routing with the global configuration command ipx routing. After IPX routing is enabled, the router builds the routing table used for routing. By default, when an IPX address is configured on a LAN or WAN interface and that interface is placed in an operational state, the IPX network address for that interface is placed in the routing table. All operational interfaces connected to the router are placed in the routing table. If only a single router is in your network, it has information about all of its connected IPX networks, and there is no need to configure static or dynamic routing. Only when two or more routers exist in the network are static or dynamic ...
Become an O’Reilly member and get unlimited access to this title plus top books and audiobooks from O’Reilly and nearly 200 top publishers, thousands of courses curated by job role, 150+ live events each month,
and much more.
Read now
Unlock full access