3.1 Power System Oscillations Leading to Simultaneous Tripping of both ends of a Transmission Line and the Tripping of one end Only on an Adjacent Line3.2 Generator Oscillations Triggered by a Combination of L-g Fault, Loss of Generation, and Undesired Tripping of three 138-kV Lines3.3 Stable Power Swing Generated During Successful Synchronization of a 200-MW Unit3.4 Major System Disturbance Leading to Different Oscillations for Different Transmission Lines Emanating from the same Substation3.5 Appearance of 120-Hz Current at a Generator Rotor During a High-Side Phase-to-Ground Fault3.6 Generator Negative-Sequence Current Flow During Unbalanced Faults3.7 Inadvertent (Accidental) Energization of a 170-MW Hydro Generating Unit3.8 Appearance of Third-Harmonic Voltage at Generator Neutral3.9 Variations of Generator Neutral Third-Harmonic Voltage Magnitude During System Faults3.10 Generator Active and Reactive Power Outputs During a GSU High-Side L-g Fault3.11 Loss of Excitation of a 200-MW Unit3.12 Generator Trapped (Decayed) Energy3.13 Nonzero Current Crossing During Faults and Mis-Synchronization Events3.14 Generator Neutral Zero-Sequence Voltage Coupling Through Step-Up Transformer Interwinding Capacitance During a High-Side Ground Fault3.15 Energizing a Transformer with a Fault on the High Side within the Differential Zone3.16 Transformer Inrush Currents3.17 Inrush Currents During Energization of the Grounded-Wye Side of a YG/Delta Transformer3.18 Inrush Currents During Energization of a Transformer Delta Side3.19 Two-Phase Energization of an Autotransformer with a Delta Winding Tertiary During a Simultaneous L-g Fault and an Open Phase3.20 Phase Shift of 30° Across the Delta/Wye Transformer Banks3.21 Zero-Sequence Current Contribution from a Remote Two-Winding delta/YG Transformer3.22 Conventional Power-Regulating Transformer Core type Acting as a Zero-Sequence Source3.23 Circuit Breaker Re-Strikes3.24 Circuit Breaker Pole Disagreement During a Closing Operation3.25 Circuit Breaker Opening Resistors3.26 Secondary Current Backfeeding to Breaker Failure Fault Detectors3.27 Magnetic Flux Cancellation3.28 Current Transformer Saturation3.29 Current Transformer Saturation During an Out-of-Step System Condition Initiated by Mis-Synchronization of a Generator Breaker3.30 Capacitive Voltage Transformer Transient3.31 Bushing Potential Device Transient During Deenergization of an EHV Line3.32 Capacitor Bank Breaker Re-Strike Following Interruption of a Capacitor Normal Current3.33 Capacitor Bank Closing Transient3.34 Shunt Capacitor Bank Outrush into Close-in System Faults3.35 SCADA Closing into a Three-Phase Fault3.36 Automatic Reclosing into a Permanent Line-to-Ground Fault3.37 Successful High-Speed Reclosing Following a Line-to-Ground Fault3.38 Zero-Sequence Mutual Coupling–Induced Voltage3.39 Mutual Coupling Phenomenon Causing False Tripping of a High-Impedance Bus Differential Relay During a Line Phase-to-Ground Fault3.40 Appearance of Nonsinusoidal Neutral Current During the Clearing of Three-Phase Faults3.41 Current Reversal on Parallel Lines During Faults3.42 Ferranti Voltage Rise3.43 Voltage Oscillation on EHV Lines Having Shunt Reactors at their Ends3.44 Lightning Strike on an Adjacent Line Followed by a C-g Fault Caused by a Separate Lightning Strike on the Monitored Line3.45 Spill Over of a 345-kV Surge Arrester Used to Protect a Cable Connection, Prior to its Failure3.46 Scale Saturation of an A/D Converter Caused by a Calibration Setting Error3.47 Appearance of Subsidence Current at the Instant of Fault Interruption3.48 Energizing of a Medium Voltage Motor that has an Incorrect Formation of the Stator Wining neutral3.49 Phase Angle Change from Loading Condition to Fault ConditionReferences
