732
create a slope. This would result in a very clean cut-
surface. Additionally, we use a tapered bit with a
5-degree angle to create the necessary slope for the
concrete to release properly from the formwork.
Once complete, the molds could be used to cre-
ate sets of hexagonal tiles, which were die cut by
the formwork manufacturer to create perfect edges.
Each of these panels is seamed together using only
tape. The formwork was supported from below
using MDF blocking of the same depth as the cut,
supporting each of the tiles to prevent any defor-
mations under the load of the concrete.
4 CONCLUSIONS
This paper discussed parametric approaches as a
generative tool in order to provide balance between
the forces driving the design and the constraints ...