HyperSwap
This chapter walks you through the process of setting up and configuring HyperSwap. It demonstrates how to set up and operate HyperSwap with three sites.
HyperSwap configuration is currently only available through command-line interface (CLI) commands. This chapter describes the needed commands.
Details about the CLI are described in the FlashSystem IBM Knowledge Center in the Reference chapter, Command-line interface section:
HyperSwap capability enables each volume to be presented by two I/O groups. The configuration ...

Get Introducing and Implementing IBM FlashSystem V9000 now with O’Reilly online learning.

O’Reilly members experience live online training, plus books, videos, and digital content from 200+ publishers.