
the case frame. Do the same for the other side
.
8b. Cover the Pixelblaze
Place the 3D-printed frame cover loosely on top
of the Pixelblaze. The back grid will keep it in
place.
8c. Glue the back grid
Dab super glue dots approximately every 5mm
on the inside corner of the back grid. Secure it in
place on the case, ensuring that it goes over the
Pixelblaze cover and lies flat against the case.
8d. Connect battery and snap-fit cover
Finally, connect the battery to the 2-pin JST-PH
port, and snap the battery cover on
.
Aaand congratulations, you have worked long
and hard to make yourself a one-of-a-kind bag!
Go ahead and put a strap onto those D-rings ...