84 䡲 Security in an IPv6 Environment
2.3.3 Mapping IEEE 802 Addresses to IPv6 Interface Identifi ers
To obtain an IPv6 interface identifi er from an IEEE 802 address, one must fi rst
map the IEEE 802 address to an EUI-64 address, as discussed previously; then
complement (fl ip) the U/L bit. e resulting bitstream is used as a universally
administered unicast IEEE 802 address.
2.3.4 Randomly Generated Interface Identifi ers
IPv6 interface identifi ers remain static over time, hence, for security reasons, a
capability is needed to generate temporary addresses. (Because of NAT/DHCP, in
an IPv4 environment it is diffi cult to track a user’s traffi c on the basis of IP address.)
However, it should be noted that many—if not most—attack techniques do not ...