Skip to Main Content
Engineering Design and Graphics with SolidWorks 2019
book

Engineering Design and Graphics with SolidWorks 2019

by James D. Bethune
June 2019
Intermediate to advanced content levelIntermediate to advanced
768 pages
20h 17m
English
Adobe Press
Content preview from Engineering Design and Graphics with SolidWorks 2019

Chapter 4 Orthographic Views

Chapter Objectives

4-1 Introduction

Orthographic views are two-dimensional views used to define a three-dimensional model. More than one orthographic view is needed to define a model unless the model is of uniform thickness. Standard practice calls for three orthographic views, a front, top, and side view, although more or fewer views may be used as needed.

There are two sets of standards used to define the projection and placement of orthographic views: the American National Standards Institute (ANSI) and the International Organization for Standardization (ISO). The ANSI calls for orthographic views ...

Become an O’Reilly member and get unlimited access to this title plus top books and audiobooks from O’Reilly and nearly 200 top publishers, thousands of courses curated by job role, 150+ live events each month,
and much more.
Start your free trial

You might also like

Engineering Design and Graphics with SolidWorks 2023

Engineering Design and Graphics with SolidWorks 2023

James D. Bethune, Nathan Brown

Publisher Resources

ISBN: 9780135401620