Skip to Main Content
Engineering Design and Graphics with SolidWorks 2019
book

Engineering Design and Graphics with SolidWorks 2019

by James D. Bethune
June 2019
Intermediate to advanced content levelIntermediate to advanced
768 pages
20h 17m
English
Adobe Press
Content preview from Engineering Design and Graphics with SolidWorks 2019

Chapter 6 Threads and Fasteners

Chapter Objectives

6-1 Introduction

This chapter explains how to draw threads, washers, and nuts. It also explains how to select fasteners, washers, nuts, and set screws.

Internal threads are created using the Hole Wizard tool, which is located on the Features toolbar. Predrawn fasteners and other standard components may be accessed using the Design Library.

All threads in this book are in compliance with ANSI (American National Standards Institute) standards—ANSI Inch and ANSI Metric threads. ...

Become an O’Reilly member and get unlimited access to this title plus top books and audiobooks from O’Reilly and nearly 200 top publishers, thousands of courses curated by job role, 150+ live events each month,
and much more.
Start your free trial

You might also like

Engineering Design and Graphics with SolidWorks 2023

Engineering Design and Graphics with SolidWorks 2023

James D. Bethune, Nathan Brown

Publisher Resources

ISBN: 9780135401620