Running Linux, 5th Edition

Running into Trouble

Often, something will not be quite right when you initially fire up the X server. This is almost always caused by a problem in your xconf.org file. Usually, the monitor timing values are off or the video card dot clocks are set incorrectly. If your display seems to roll or the edges are fuzzy, this is a clear indication that the monitor timing values or dot clocks are wrong. Also be sure you are correctly specifying your video card chipset, as well as other options for the Device section of xconf.org. These days, there is only one server binary, which loads the module needed for the graphics card in question. The module that loads depends on your Device settings.

If all else fails, try to start X "bare"; that is, use a command such as:

Xorg > /tmp/x.out 2>&1

You can then kill the X server (using the Ctrl-Alt-Backspace key combination) and examine the contents of /tmp/x.out. The X server reports any warnings or errors—for example, if your video card doesn't have a dot clock corresponding to a mode supported by your monitor. This output can be very helpful in diagnosing all kinds of problems. Examine it closely if your X server does not start up at all, does not provide the resolutions you wanted, or shows a flaky, snowy, or otherwise insufficient picture. Even if everything works to your satisfaction, you might want to check this file for interesting information that the X server has found out about your hardware. The lines starting with (**) contain data that you ...