December 2010
Beginner
455 pages
10h 47m
English
Leave your circuit board intact from Project 5. You're just going to add a potentiometer to this circuit, which will allow you to change the speed of the lights while the code is running.
All of the parts for Project 5 plus....
| 4.7KΩ Rotary Potentiometer | ![]() |
First, make sure your Arduino is powered off by unplugging it from the USB cable. Now, add the potentiometer to the circuit so it is connected as shown in Figure 3-2 with the left leg going to the 5v on the Arduino, the middle leg going to Analog Pin 2, and the right leg going to ground.
Figure 3-2. The circuit for ...
Read now
Unlock full access