July 2002
Intermediate to advanced
608 pages
14h 52m
English
To enable MPLS TE SNMP traps, use the following global command.
| Command | Modifiers | Default | Use |
|---|---|---|---|
| snmp-server enable traps mpls traffic-eng | {down | reroute | up} | Disabled | Enables MPLS TE traps for tunnel down, tunnel reroute, or tunnel up events. If you enable snmp-server enable traps mpls traffic-eng, all three traps are enabled. |
All other commands in global configuration mode start with mpls traffic-eng.
| Command | Modifiers | Default | Use |
|---|---|---|---|
| …auto-bw timers | [frequency 1-604800 seconds] | 300 seconds | Determines how often tunnel bandwidth is polled for all interfaces with auto bandwidth enabled. |
| …link-management timers bandwidth-hold | 1-300 seconds | 15 seconds | Determines how long bandwidth requested in a Path message is set aside ... |
Read now
Unlock full access