September 2016
Intermediate to advanced
495 pages
9h 37m
English
Now let's assemble the different components of this project. This is a schematic to help you out:

First, connect the power. Connect the Arduino Uno 5V to the red power rail on the breadboard, and the GND pin to the blue power rail. Also, place all the main components on the breadboard.
After that, for the DHT11 sensor, follow the instructions given by the schematic to connect the sensor to the Arduino board. Make sure you don't forget the 4.7k Ohm resistor between the VCC and signal pins.
We are now going to connect the photocell. Start by placing the photocell on the breadboard in series with the 10k Ohm resistor. After that, ...
Read now
Unlock full access