December 1999
Intermediate to advanced
258 pages
5h 23m
English
If you recall the discussion about match, there is a standard "size" of inputs and outputs for all RF components which is 50 Ω (ohm) impedance. When the output of one device and the input of the next device are both 50 Ω (or nearly so), then the two devices are connected directly and the slight mismatch (leaking) is tolerated. However, sometimes one of the devices has an input or output which is so far from 50 Ω that trying to connect it to another device with the proper input (50 Ω) causes a horrible mismatch (leaking). What is needed in this ...
Read now
Unlock full access