Make: Volume 78

marks (Figure

Ff

)

I lay the blade in place, with

one end even with the back of the deck and the

other end sitting on the drawer front (Figure

Gg

)

.

The back of the blade (without teeth) is the side

you’ll want to tear against. The teeth side leaves

a very ragged edge on the sandpaper. Trace the

holes in the blade onto the deck and drawer front

(Figure

Hh

).

Using a 5/8" Forstner bit in a drill press, I

carefully drill the front hole until it is flush with

the deck (Figure

Ii

)

. Then using a chisel, I trim

the edges of the hole square (Figure

Jj

)

.

To attach the blade, I use one #6 washer under

the blade, and one #6× ¾" screw and a finish

washer ...