
Then, following the directions on the PVC
cement can, solvent-weld the pipe cap with the
attached PTC fitting to the pipe (Figure
F
). Twist
the cap as you attach it to make sure there are no
leaks in the solvent-welded connection.
5. ATTACH CYLINDER TO BASE
Drill a ¾" diameter hole in the center of the 2×4
guide piece. Next, drill a ¾" through-hole along
the centerline of the top of the base, 10" from one
side, as shown in Figure A.
Position the hole in the guide piece with the
hole in the base so that the two holes exactly
align. Attach the guide piece to the base with 4
deck screws.
Now, attach the mounting flange square socket
to the under ...