
from these ®gures, only the following external components are required to have
a working microcontroller:
X1 Crystal (e.g. 12 MHz)
C1, C2 33 pF capacitors
C3 10 mF, 10 V electrolytic capacitor
R1 8.2K, 0.125 W resistor
We shall be using the circuit in Fig. 1.4 in all of the projects described in this
book, except the last project which is based on a 40-pin device. The crystal
chosen for the projects is 12 MHz, which gives a basic instruction timing of
1 ms. The power supply current of the AT89C2051 is around 15 mA, but a
power supply which can deliver up to a few hundred milliamperes is
recommended so that the interface circuitry attached to the microcontroller ...