September 2006
Intermediate to advanced
504 pages
11h 49m
English
In this lab, you will configure routers R1 and R2, which are shown in Figure 5-33, for RTP header compression (cRTP) and compare bandwidth usage before and after enabling cRTP.

When you issue the show interfaces command for a router’s interface, many of the statistics shown are, by default, five-minute average values. In this lab you will view the input rate on one of router R2’s serial interfaces, and to avoid having to wait the default load interval of 5 minutes, in this task you will set the load interval to its ...
Read now
Unlock full access