September 2016
Beginner to intermediate
593 pages
12h 12m
English
Now that the hardware is connected, you can use some software provided by Polulu to control the servos. Let's do this using your personal computer. First, download the Polulu SW from www.pololu.com/docs/0J40/3.a, and install it based on the instructions on the website. Once it is installed, run the software, and you should see this screen:

First, you will need to change the configuration in Serial Settings, so select the Serial Settings tabs, and you should see this:

Make sure that USB Chained is selected; ...
Read now
Unlock full access