Linux Networking Cookbook

14.11. Monitoring Disk Usage

Problem

You want to keep an eye on some of your disk partitions and see how full they are getting.

Solution

First, you need to edit snmpd.conf, adding the partitions you wish to monitor:

	## /etc/snmp/snmpd.conf
	disk /var
	disk /home

Then, restart snmpd:

	# /etc/init.d/snmpd restart

Try this in mrtg.cfg:

	# Monitor disk usage of /var and /home partitions
	#
	Target[server.disk]: dskPercent.1&dskPercent.2:password@localhost
	Title[server.disk]: Disk Partition Usage
	PageTop[server.disk]: <H1>Disk Partition Usage /var and /home</H1>
	MaxBytes[server.disk]: 100
	ShortLegend[server.disk]: % Y
	Legend[server.disk]: % used
	LegendI[server.disk]: /var
	LegendO[server.disk]: /home
	Options[server.disk]: gauge,growright,nopercent
	Unscaled[server.disk]: ymwd

Make sure that LoadMIBs: /usr/local/share/snmp/mibs/UCD-SNMP-MIB.txt is in the Global Config Options section. Run these commands to load the changes:

	# env LANG=C mrtg /etc/mrtg.cfg
	# indexmaker --output=/var/www/mrtg/index.html /etc/mrtg.cfg

Mind your filepaths, because they vary on different Linux distributions, and remember to run the first command until it quits emitting error messages, which should take no more than three tries.

Discussion

This only works on disk partitions—you cannot select just any old directory.

Give MRTG an hour or so, then check your work with the df-h command:

	$ df -h Filesystem Size Used Avail Use% Mounted on /dev/hda1 14G 2.3G 11G 17% / /dev/hda3 5G 1.8G 3.2G 36% /usr /dev/sda1 31G 6.5G 24G 22% /home ...