
202 Building a Linux HPC Cluster with xCAT
apc.tab
This table gives xCAT the ability to power on or off any equipement connected to
the APC MasterSwitch. It is intended for equipment that is not controlled by an
MPA card (network switch, Equinox, Myrinet switch, etc.).
If your nodes do not use MPA hardware but they are connected to an APC
MasterSwitch, then you still are able to control them through entries in this table.
Example B-6 is the description of the apc.tab table.
Example: B-6 Description of apc.tab table
EquipmentApcToUse,ApcPortNumber
Table B-8 Definition of apc.tab parameters
Parameter Description Possible values
Equipment This is the ...