Appendix A. xCAT commands 137
This action is performed using two different methods. If valid_node_name is in
xCAT node format then the range is enumerated to one less than
number_of_sequential_nodes. If not in xCAT node format, then a sorted
nodelist.tab(5) is used to return the node range. This operator supports nodes
only.
7. noderange checks for a single node name or group name.
8. noderange checks for the range operator (default -). Ranges are performed
first by validating that both the start and end nodes or groups defining the
range exist and if so the range is returned based on the content of
nodelist.tab(5), nodetype.tab(5), and nodemodel.tab(5). If the start and end
nodes or groups defined in the range do not exist, if both are in ...