
ZOMBIE OUTBREAK!
SETUP AND TESTING
Use copious amounts of duct tape to fasten
your zombie (or scary object of preference)
to the zombie mounting arm. Make sure the
transmitter joysticks and switches are off or in
neutral. Turn the transmitter power on and then
turn the 12V battery switch on (it’s good practice
to turn on the transmitter before the receiver in
most R/C applications).
Fully close the valves to both air cylinders and
then open a half-turn initially (you’ll adjust these
in a bit). Carefully open the main valve on the air
tank fully. If you hear air leaks, turn the air tank
valve off and slightly tighten the compressed air
fittings ...