
PROJECTS: Mobile Handwash Station
½" drill bit or hole saw to cut the hole.
1b. Separate the two pieces of a ½" bulkhead
union washer fitting (Figure
A
), leaving one
washer per piece. Push the piece with the
threading through the hole you have cut and screw
the other side on, on the underside of the lid.
1c. Wrap a few layers of PTFE tape (Figure
B
)
around the threaded areas of two ½"×¾" PVC male
reducer adapters (Figure
C
).
1d. Screw the PVC reducers into the top and
bottom sides of the bulkhead fitting.
1e. Cut a 3" length of ¾" PVC pipe (Figure
D
) and
slide it into the PVC reducer that’s on top of the lid.
1f. Slide a ¾" PVC elbow (slip × ...