April 2020
Intermediate to advanced
294 pages
7h 53m
English
At this point, we have all the information that we need to develop a detailed schematic diagram for our project, as follows:

This design is fairly straightforward. First, the pyboard is supplied 5 volts through the USB or VIN pin. The 5-volt power rail is used to power the LEDs and the RobotDyn PCA8574. The pyboard onboard regulator also converts this rail into a 3.3-volt power rail that is used as the pushbutton power supply.
Next, the negative side of the LEDs, the cathode, is connected to the X1, X2, and X3 pins. These pins are associated with an internal timer that allows us to generate a PWM signal on them. ...
Read now
Unlock full access